Published on Apr 02, 2024
When a disaster occurs it is very important to grasp the situation as soon as possible. But it is very difficult to get the information from the ground because there are a lot of things which prevent us from getting such important data such as clouds and volcanic eruptions.
While using an optical sensor, large amount of data is shut out by such barriers. In such cases, Synthetic Aperture Radar or SAR is a very useful means to collect data even if the observation area is covered with obstacles or an observation is made at night at night time because SAR uses microwaves and these are radiated by the sensor itself. The SAR sensor can be installed in some satellite and the surface of the earth can be observed.
To support the scientific applications utilizing space-borne imaging radar systems, a set of radar technologies have been developed which can dramatically lower the weight, volume, power and data rates of the radar systems. These smaller and lighter SAR systems can be readily accommodated in small spacecraft and launch vehicles enabling significantly reduced total mission cost.
Specific areas of radar technology development include the antenna, RF electronics, digital electronics and data processing. A radar technology development plan is recommended to develop and demonstrate these technologies and integrate them into the radar missions in a timely manner. It is envisioned that these technology advances can revolutionize the approach to SAR missions leading to higher performance systems at significantly reduced mission costs.
The SAR systems are placed on satellites for the imaging process. Microwave satellites register images in the microwave region of the electromagnetic spectrum. Two mode of microwave sensors exit- the active and the passive modes. SAR is an active sensor which carry on -board an instrument that sends a microwave pulse to the surface of the earth and register the reflections from the surface of the earth.
One way of collecting images from the space under darkness or closed cover is to install the SAR on a satellite . As the satellite moves along its orbit, the SAR looks out sideways from the direction of travel, acquiring and storing the radar echoes which return from a strip of earth's surface that was under observation.
The raw data collected by SAR are severely unfocussed and considerable processing is required to generate a focused image. The processing has traditionally been done on ground and a downlink with a high data rate is required.
This is a time consuming process as well. The high data rate of the downlink can be reduced by using a SAR instrument with on-board processing.
The X-band SAR instrument demonstrator forms the standardized part or basis for a future Synthetic Aperture Radar (SAR) instrument with active front- end. SAR is an active sensor. Active sensors carry on-board an instrument that sends a microwave pulse to the surface of the earth and register the reflections from the surface of the earth. Different sensor use different bands in the microwave regions of the electromagnetic spectrum for collecting data. In the X-band SAR instrument, the X-band is used for collecting data.
| Are you interested in this topic.Then mail to us immediately to get the full report.
email :- contactv2@gmail.com |
